On the sensor details page, there is a button to 'Set sensor covered time'.If you are doing thermal monitoring (i.e. if you don’t have a calibrated mix to assign to the pour) then this will be new to your site. Once you click it, you’ll be prompted to enter the time the sensor was covered by concrete.
Once you have a covered time set, it’ll show up on the web chart.
Now, when you download PDF reports for sensors and differentials, they will be filtered to include only data between the covered time of each sensor and until the finished monitoring time.
Setting a finished monitoring time
Once you’ve finished monitoring the pour, the Converge system you’re using might continue to capture data from the sensors for some time afterwards. If you don’t want that showing up in reports, you can set a ‘finished monitoring’ time on the pour. Once set, PDF reports won’t show data after this time. This will also move the pour to the ‘Inactive’ tab on the list of pours.
Note: This feature won’t stop the platform from receiving data for your sensors, so if you realise you need to change the finished monitoring time to a later date you can do so. Also, you’ll still be able to view data after the finished monitoring time on the web platform. This feature simply filters the data used in reports.
To set a finished monitoring time, navigate to the pour details screen and click the 'Finish monitoring' button at the top of the screen.
You'll be prompted to enter the time after which you no longer wish to monitor the pour:
Once you’ve set the covered time, the button on the pour details screen changes to 'Edit finish time'. This button will bring up a dialog from which you can edit the time or remove it altogether.
